Rubber seals are the guarantee for the normal operation of the equipment and the core of the equipment. Therefore, the installation of rubber seals is very important. Any error in the installation process may affect the sealing performance and then affect the normal operation of the rubber seal equipment. Therefore, it is necessary for the operator to understand the precautions for installing rubber seals before installation. In addition, the storage work before installation of the rubber seal should also be done.

Precautions for installation of rubber seals:

1. Check the piston, cylinder tube and the relevant surface where the guide sleeve is installed, and the bag is clean, without burrs and edges.

2. The installation tools are required to be smooth, without edges, and sharp corners to ensure that the seals will not be damaged in any form during the installation process (special installation tools for rubber seals should be used).

3. A small amount of grease can be applied to the seals and related surfaces of the cylinder during installation to facilitate the installation, but no residual grease is allowed between the rubber elastic body and the sliding seal ring, otherwise it will affect the sealing performance.

4. Whether it is vertical or horizontal installation, the coaxiality between the piston and the cylinder should be maintained. Excessive eccentricity may damage the seal.

5. The installation speed should not be too fast, otherwise the seals will be damaged.

Rubber seal storage:

During storage and storage, the rubber seal should be put into a sealed PTFE or other moisture-proof plastic bag, and the storage date should be recorded, and then stored in a dark place to avoid high temperature or direct sunlight and other poor storage and storage. The sealing performance of rubber seals.